CG50B Corner protection systemVinyl corner bump, excellent budget protection of corners from impacts.

This bump is suitable for any room where there are no gurneys. An excellent solution for protecting corners in reception rooms, offices, offices and any walk-through areas. And also due to their antibacterial characteristics, these bumpers are suitable for medical centers and it is an ideal choice to protect corners from the wear of interior decoration. 

Accessories:Vinyl profile - thickness 1.5 mm

Mounting:Determine the height of the corner bump.

1.  
2. If you need to trim the bump, use a mounting saw or a construction knife and a metal ruler (square).
3. Make sure the wall is dry and clean.
4. Remove all the irregularities of the wall, for best results.
5. Before applying the adhesive, wipe both sides of the bump to make sure that there is no dust and dirt on the surfaces.
6. Apply the glue only to the wall surface, use a D2 or B3 spatula to distribute the glue. It is recommended to use a water-based contact adhesive (KIILTO EXTRA, DENLAKS TK-580). Consumption of 300-350 g of glue for each 1 m2.
7. Allow the glue to harden, under normal conditions it will take from 10 to 15 minutes. However, the duration of curing depends on temperature and humidity.
   Important: Read the specification of the adhesive or other adhesives before applying.
8. Place the bump sheet on the wall, align and press it in place manually.
9. Roll up the bump strip using a pressure roller. Start rolling in the center of the sheet and move towards the edges. After installation, remove excess glue.

Note: This model does not have any accessories in the package.

• Каталог - Системы защиты стен и углов АРФЕН 2018
• Цветовая палитра - Отбойники
• CG25B, CG50B, CG76B - Монтаж