WG154–204–304 Chair Wall Protection System

Vinyl panels protect the interior from wear. Due to its thickness, it can be used in the narrowest possible rooms, as well as ideal protection from the friction of the walls with chairs. Of all the wall bumpers, this model is the most compact and budget.  These panels can also be used as door protection, thereby you will remove the eternal problem of shabby doors in public places. And due to its dirt-repellent properties, your doors will always be clean. Vinyl panels can be equipped with corner protective pads such as CG50B and CG76B.

Accessories:

Vinyl profile - 2 mm

Installation:

1. Determine the installation height of the wall covering.
2. If you need to trim the bump, use a mounting saw or a construction knife and a metal ruler (square).
3. Make sure the wall is dry and clean.
4. Remove all the irregularities of the wall, for best results.
5. Before applying the adhesive, wipe both sides of the bump to make sure that there is no dust and dirt on the surfaces.
6. Apply the glue only to the wall surface, use a D2 or B3 spatula to distribute the glue. It is recommended to use a water-based contact adhesive (KIILTO EXTRA, DENLAKS TK-580). Consumption of 300-350 g of glue for each 1 m2.
7. Allow the glue to harden, under normal conditions it will take from 10 to 15 minutes. However, the duration of curing depends on temperature and humidity.
   Important: Read the glue specification or other adhesives before applying.
8. Place the bump sheet on the wall, align and press it in place manually.
9. Roll up the bump strip using a pressure roller. Start rolling in the center of the sheet and move towards the edges. After installation, remove excess glue.

Note: This model is equipped with accessories such as internal and external angular transition elements.

• WG154,204,304,1004 ТЕХ КАРТА
• Каталог - Системы защиты стен и углов АРФЕН 2018
• Цветовая палитра - Отбойники